Previous slide
Next slide
SONIC 3500, the drilling attachment has higher productivity than a pneumatic drill. Diesel consumption is greatly reduced compared to a pneumatic set (trailer + compressor). The operator can operate the drill from outside the cabin, using the radio control, not exposing himself to risk situations. In a matter of minutes, with a single piece of equipment, three functions are achieved: drilling, demolition and excavation.
Advantages:
- Multiple drilling positions
- Reduction of diesel consumption
- High Production
- Operational Simplicity and Mobility
- Low Investment and Maintenance Cost
Characteristics:
Technical Data: |
|---|
Fully hydraulic and needs a single operator |
Drilling Diameter between 2.1/2″ to 4″ (64 à 102 mm) |
Digital panel inside the cabin with interactive display for monitoring and Depth Gauge (as an optional item) |
Rod Changer, Rod Greaser, Hydraulic Centralizer and Hose Stretcher |
Cleaning System with Water Injection or Dust Collector (as an optional item) |
An air compressor 250cfm @100 psi is required along with the excavator for proper operation |
AVAILABLE COMPONENTS | |
|---|---|
STANDARD | |
Secondary Rod Changer (1 rod) | |
Hydraulic Centralizer (Exclusive for SONIC 2000, just top hammer) | |
Anti-Jamming | |
OPTIONS | |
Protection (Hose and Valves) | Water Tank |
Emergency Button (installed on side of the mast) | |
Nitrogen Charger | Depth Gauge |
Protection (Feed Motor and Feed) | Dust Collector (Primary and Secondary) |
Drifter W 19:
Technical Information | |
|---|---|
Work Pressure | 120-140 bar (2.030 PSI) |
Impact Power | 19 Kw (26 hp) |
Impact Frequency | 2.600 bpm |
Weight | 237 kg |
Rotation | 0 – 150 rpm |
Rotation Torque | 750 Nm (533 lbf/ft) |
Thread Type | T38 / T45 |
Drilling Diameter | 2.1/2″ – 3.1/2”” |
Magazine (Rod Quantity) | Carrousel 6 + 1 |
Length of Rods | 3,66m (12”) |
Dimensions | |
|---|---|
Weight | 3.500kg |
Width | 3.000mm |
Length | 7.800mm |
Height | 2.000mm |
